Philips Expression MR400 - Auto Mode

12‐16MonitoringNIBPExpressionMR400InstructionsforUse
Auto Mode
SetsthemodeusedtotakeNIBP readings.
Note
A manual reading will not restart this cycle time.
Thefollowingoptionsareavailable:
• Offtakesreadingsmanually(Manualmode),wherereadingsareinitiatedbypressingthe
NIBPStart/Stopkey;seeMakingManualMeasurementsonpage12‐7fordetails.(Default)
• Ontakesreadingsautomatically,wherewhenselected(orsinceleavingsuspendmode),
thefirstreadingmustbein itiated
bypressingtheNIBPStart/Stopkeyandthenall
subsequentreadingswillbetakenattheselectedinterval;seeMakingAutomatic
Measurementsonpage12‐6forothersetupdetails.
TosetthemodeforNIBPreadings
2 SelectInterval.
TheIntervalmenuappears.Thecurrentsettingishighlighted.
3 Selectthedesired
minute(s)fortheinterval:
1Min
2Min
3Min
5Min
10Min
15Min
20Min
30Min
Thesettingischanged.
Step Action
1 SelecttheNIBPVSbox.
TheNIBPmenuappears.Currentsettingsaredisplayed.
2LocateAutoModeandselectthedesiredsetting:
Off
On
Thesettingisentered.
Step Action