Philips Expression MR400 - Page 113

ExpressionMR400InstructionsforUseGettingStarted3‐27
PresstheSetupkeyandthentheMonitor
key.OntheMonitorSetupmenu,select
Service(Bio‐Med).
NOTE
Some menu items require entry of a password for access; see page 2-23.
ToaccesstheSERVICE(BIO‐MED)menuitems
1 Revision Information
2 Simulation Mode
3Gas Cal
4 System Config
5ECG Tests
6NIBP Tests
7 Backlight Brightness
8 Service Utilities
Step Action
1PresstheSetupkeyandthentheMonitorkey.
TheMonitorSetupmenuappears.Currentsettingsaredisplayed.
2OntheMonitorSetupmenu,selectService(Bio‐Med).
TheService(Bio‐Med)sub‐menuappears.
3 Selectthedesiredmenuitem(somemenusarepassword
protected):
RevisionInformation
SimulationMode
GasCal
SystemConfig
ECGTests
NIBPTests
BacklightBrightness
ServiceUtilities
Theselectionisentered(orenterthecorrectpasswordforaccess).
4 Selectthedesiredmenuoritem,exceptSimulationMode,whichis
selectableontheService(Bio‐Med)menu.
Thesettingisentered.
1
2
3
4
5
6
7
8