Philips Expression MR400 - Page 79

ExpressionMR400InstructionsforUseSystemOverview2‐17
• Powersourcechange‐of‐stateindicationsaredisplayed.
3 Indicates the battery time-remaining (given in an hours:minutes
format) until power will be exhausted for the wECG module; also,
indicates that the wECG module’s communication with the MR400
is good. For detailed battery information regarding the wECG
module batteries, see Status Information Panel on page 2-18.
4 Indicates the current power type used by the MR400 (AC power in
this example).
5 Indicates that an IP5 is communicating with the MR400.
1 Indicates a low battery condition and the approximate time (given
in an hours:minutes format) until power will be exhausted for a
module battery (wSpO2 in this example); also, indicates that the
module’s communication with the MR400 is good.
WARNING
A red battery symbol indicates that the module
batteries have fallen below the required operational
output and module shutdown with loss of monitoring
will occur. Immediately replace the module batteries to
avoid a loss in monitoring.
2 Indicates that the cart batteries are the current power type used by
the MR400 and the approximate time (given in an hours:minutes
format) until power will be exhausted.
WARNING
A red battery symbol indicates that the main batteries
in the MR400 have fallen below the required
operational output and system shutdown with loss of
monitoring will occur. Immediately locate an AC outlet
and connect the MR400 to avoid a loss in monitoring.
1
2