Ricoh M0A0 - NVRAM Data Upload;Download; Uploading Content of NVRAM to an SD Card

5.System Maintenance
206
NVRAM Data Upload/Download
Uploading Content of NVRAM to an SD card
Do the following procedure to upload SP code settings from NVRAM to an SD card.
 This data should always be uploaded to an SD card before the NVRAM is replaced.
 Make sure that the write protection of an SD card is unlocked
1. Do SP5-990-001 (SMC Print) before turning OFF the main power. You will need a record of the NVRAM settings
if the upload fails.
2. Turn OFF the main power.
3. Remove the SD card slot cover [A].
4. Insert the SD card into SD slot 2 [A].