Ricoh M0A0 - User Authentication for Specific MFP Applications

4.Appendices: Software Configuration
188
Bit 7 = 1
As Bit 1 = 1 is the most restrictive of the three, it will take presedence over the other two and only administrators will be
able to access the DS via WIM.
 In order for SP5-885-020 to have any effect, the Document Server must be enabled (SP5-967-001=0). For
information about SP5-967-001, refer to Disabling the Document Server using System SP5-967-001 and
Printer SP1-006-001.
 Access to the entire "Job" menu can be restricted using SP 5-888-001. For details, refer to Use of SP 5-888-
001 to restrict access to the "Job" menu on WIM.
User Authentication for Specific MFP Applications
The SP5-420 settings enable/disable User Authentication for specific MFP applications.
SP 5-420 User Authentication Value (Default: 0)
SP 5-420
User Authentication
Value (Default: 0)
SP5-420-001
Copy
0 (ON)
1 (OFF)
SP5-420-011
Document Server
SP5-420-021
Fax
SP5-420-031
Scanner
SP5-420-041
Printer
1. Enable User Authentication for the device as a whole:
User Tools > System Settings > Administrator Tools > User Authentication Management
2. Use the SP5-420 settings to specify the applications to which User authentication is to apply.