To Next Page

To Previous Page

2.Installation

Installation Procedure

Removal of packing materials and shipping retainers

 When lifting the machine, use the inset grips on both sides. The machine could break or cause an injury if

dropped.

1. Remove the machine from the box.

2. Check the items in the package.

3. Remove the adhesive tape attached to the machine's exterior.

 Pull out the paper tray, and remove the adhesive tape [A] on its side.

4. Remove the protective materials.

 After installing this machine or replacing the fusing unit, make sure to raise the envelope lever before using

the machine. The envelope lever is green, positioned to the right of the user when facing the back cover of the

machine. Lower this lever only when printing on envelopes.

Ricoh M0A0 User Manual

Questions and Answers: