To Next Page

To Previous Page

2.Mechanism

Controlling the Power Supply

Exiting Energy Saving Modes

Because this model of Smart Operation Panel has no hardware keys, the MFP exits from energy saving mode when the

user does one of the following:

 Touches the display panel

 Lifts the ADF

 Sets an original in the ADF

Screen Startup Mode

Startup Modes

There are two screen startup modes. The factory default setting is Normal.

1. Normal

This is the standard startup mode. When the main power of the MFP is turned ON, the control panel starts up using

less power compared to Quick mode.

2. Quick

By preparing for the next startup when the machine shuts down, the control panel starts up faster than in Normal

mode.

Changing the Screen Startup Mode

Screen Startup Mode can be changed in Screen Features.

Select [Screen Features] > [SYSTEM] > [Screen Device Settings] > [Screen Startup Mode], and then select [Normal] or

[Quick].

 In the following cases, the control panel starts up in Normal mode even if [Quick] is selected.

 The power cord has been disconnected from the power outlet after the last shutdown.

 The MFP is turned ON after being turned OFF due to reasons such as a power failure.

 The MFP was not properly shut down the last time it was turned OFF.

Ricoh M0A0 User Manual

Questions and Answers: