3.System Maintenance
49
Software Update
Updating the Smart Operation Panel
There are four methods to update the Smart Operation Panel. The method is different depending on what you want to
update.
1. Installation/update from an SD card
2. Package update
3. Installation/update from the eDC Server
4. Installation/update from Application Site
Installation/update
from an SD card
ï‚· This is the only method to install an older version of
currently installed software.
ï‚· Enter the recovery mode to update the control panel
firmware.
 Use the installation screen in the control panel’s service
mode to update applications.
ï‚· You can install or update multiple applications at once.
ï‚· You can also uninstall an application.
Uses the Package update function of the GW+ controller to
update the software.
ï‚· The software is updated in the following order: controller
firmware, applications, and then the control panel
firmware.
ï‚· The procedure for updating the control panel firmware is
the same as when updating from an SD card using
Recovery mode.
Installation/update
from the eDC Server
Downloads applications from the eDC Server for installation
or update.
This method is mainly for paid applications. A product key is
required when an application is installed for the first time.
Installation/update
from Application Site
Installation and Updating of applications and firmware
update can be done from Application Site. When
administrator authentication is enabled, an administrator
privilege is required to start Application Site. If you log in to
the operation panel service mode, however, you can use it