Ricoh M0A0 User Manual

2.Installation
52
3. Make sure that "Admin. Authentication" is ON.
User Tools > Machine Features > System Settings > Administrator Tools > Administrator Authentication
Management > Admin. Authentication
If this setting is OFF, ask the customer to change the setting to ON before you perform the installation procedure.
4. Make sure that "Administrator Tools" is enabled (selected).
User Tools > Machine Features > System Settings > Administrator Tools >
Administrator Authentication Management> Available Settings
If this setting is disabled (not selected), ask the customer to enable (select) the setting before you perform the
installation procedure.
 See the Operating Instructions (Security Guide) for the factory defaults.
Seal Check and Removal
Before opening the box (corrugated envelope), make sure that the seal has not been broken or peeled off. If the seal is
peeled off, it will leave a mark on the box.
If the seal has been broken or peeled off, even if only partially, this is considered an arrival defect.
You must check the box seals to make sure that they were not removed after the items were sealed in the box at the
factory before you do the installation.
1. Check the box seals [A] on each corner of the box.
 Make sure that a tape is affixed in each corner.
 The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not install the components in the
box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
3. When the seal is removed, you would see "VOID" marks [B]. In this condition, they cannot be attached to the box
again.

Ricoh M0A0 Specifications

General

Brand	Ricoh
Model	M0A0
Category	All in One Printer
Language	English