Ricoh M0A0 - Page 640

3.Troubleshooting
14
Code
Meaning
Suggested Cause/Action
sending to another machine.
 Check for line problems.
Cross reference
See error code 0-04.
0-07
No post-message response from the other
end after a page was sent
 Check the line connection.
 Replace the FCU.
 The other end may have jammed or run out of paper.
 The other end user may have disconnected the call.
 Check for a bad line.
 The other end may be defective; try sending to another
machine.
0-08
The other end sent RTN or PIN after
receiving a page, because there were too
many errors
 Check the line connection.
 Replace the FCU.
 The other end may have jammed, or run out of paper or
memory space.
 Try adjusting the tx level and/or cable equalizer
settings.
 The other end may have a defective modem/FCU; try
sending to another machine.
 Check for line problems and noise.
Cross reference
 Tx level - NCU Parameter 01 (PSTN)
 Cable equalizer - G3 Switch 07 (PSTN)
 Dedicated tx parameters in Service Program Mode
0-14
Non-standard post message response code
received
 Incompatible or defective remote terminal; try sending
to another machine.
 Noisy line: resend.
 Try adjusting the tx level and/or cable equalizer
settings.
 Replace the FCU.
Cross reference
See error code 0-08.
0-15
The other terminal is not capable of specific
functions.
The other terminal is not capable of accepting the following
functions, or the other terminal’s memory is full.
 Confidential rx
 Transfer function
 SEP/SUB/PWD/SID
0-16
CFR or FTT not detected after modem
 Check the line connection.