2.Installation
77
2. Touch [Format].
3. Wait for the machine to finish formatting the hard disk.
Do not touch the power switch while the hard disk format is in progress. Wait for the machine to tell you that the
formatting is finished.
4. Turn the main power OFF and back ON again after the message tells you formatting is finished.
5. Enter the SP mode.
6. Turn the main power OFF and back ON again.
7. Ask an administrator to register an HDD authentication code in the machine.
If the HDD Authentication Code is not registered, the function of the enhanced security HDD is not activated.
To Next Page
Loading...
Need help?
General
