CMU Popup Menu Setup
1100.4903.12 4.15 E-10
Code Number Code number of the option to be installed
Status Indication of the next operating step to perform
Progress Progress of the enabling procedure
Of the five fields, only the Code Number can be edited. The name of the option
being enabled and the serial number of the CMU are automatically entered into the
corresponding fields.
! Enter the code number of the option in the input field Code Number.
! Confirm the entry using Enter.
The option is automatically enabled.
Remote control
–
Hardware
Options /
Hardware
Equipment /
Firmware
Versions
The Hardware Options section lists all hardware options for the current CMU model
(CMU200 or CMU300). Additional hardware accessories are listed in the Hardware
Equipment section. The table shows the product index or not installed, if the CMU
is not equipped with the hardware option or equipment.
Note: An comprehensive list of the hardware equipment of the instrument is
provided in the Info menu; see p. 4.18.
The FW version for RXTX Board 1 (uP1) and RXTX Board 2 (uP2) is displayed in
the Firmware Versions section. This information is mainly intended for service
purposes.
Further information on the options can be found in the data sheet. Installation and
removal of hardware options is described in Chapter 4 of the CMU service manual.
Note on Front Module controller
The version of the Front Module controller has an impact on the shut
down process of the instrument; see Chapter 1, section Switching off
the Instrument. When operating instruments equipped with an FMR 6
in remote control mode, it is recommended to disable the nonvolatile
RAM, see command SYSTem:NONVolatile:DISable in Chapter 6.
Remote control
SYSTem:OPTions?
*OPT?
To Next Page
Loading...
