Rohde & Schwarz CMU 200 - Page 273

CMU CMU Base System
1100.4903.12 6.7 E-10
STATus:OPERation:CMU:SUM<nr>:CMU<nr_event>:ENABle <Number> Enable part
<Number>
Parameter description Def. value Default unit FW vers.
0 to 32767 Enable part – – V1.20
Command description
This command enters a number to be interpreted as a bit pattern in the ENABle part of the
STATus:OPERation:CMU:SUM<nr>:CMU<nr_event> register (<nr> = 1 to 2; <nr_event> = 1 to 15). If a bit is set
the corresponding event is reported in the summary bit of the status byte.
STATus:OPERation:CMU:ALL? Query all operation registers
Response
Parameter description Def. value Default unit FW vers.
0 to 32767, ... ,
0 to 32767
Event part of all CMU operation registers – – V1.20
Command description
This command queries the EVENt parts of all STATus:OPERation:CMU:SUM<nr>:CMU<nr_event> registers.
The result is returned as a list of 30 integer values separated by commas.
STATus:OPERation:CMU:CLEar Clear all operation registers
Command description FW vers.
This command clears the EVENt parts of all STATus:OPERation:CMU:SUM<nr>:CMU<nr_event>
registers (<nr> = 1 to 2; <nr_event> = 1 to 15).
V1.20
STATus:QUEStionable[:EVENt]? Event part
Response
Parameter description Def. value Default unit FW vers.
0 to 32767 Event part – – V1.20
Command description
This command queries and deletes the contents of the EVENt part of the STATus:QUEStionable register.
STATus:QUEStionable:ENABle <Number> Enable part
<Number>
Parameter description Def. value Default unit FW vers.
0 to 32767 Enable part – – V1.20
Command description
This command enters a number to be interpreted as a bit pattern in the ENABle part of the
STATus:QUEStionable register. If a bit is set the corresponding event is reported in the summary bit of the status
byte.