CMU Manuals
1100.4903.12 0.3 E-10
What's new in this Revision...
This operating manual describes version V3.40 of the CMU base software including RF and Audio
measurements and the IQ-IF interface. Compared to previous versions, this new firmware provides
numerous extensions and improvements. The most important new features described in this manual
are listed below.
New Features Description Refer to...
RF User Correction Correction of a frequency and level response in the test setup by
means of interpolation tables.
Chapter 1,
→ RF User Correction
RF Aux Tx Second, configurable RF signal in function group RF (with option
CMU-B95, Additional RF Generator).
Chapter 4, RF Measurements
→ Generator Settings
Extended selftests Selftests for new hardware components and generators added Chapter 4,
→ Maintenance
*GTL Device-specific Go to Local command, also works with serial
interface
Chapter 5,
→ Return to Manual Operation
Extended status
reporting system
Invalid measurement results cause bit no. 4 of the
STATus:OPERation register to be set.
Chapter 5,
→ STATus:OPERation Register
Higher data rates The serial interface supports data rates up to 115200 baud. Chapter 4,
→ Serial Interfaces
To Next Page
Loading...
Need help?
General
