wsm M7040 - Page 285

TRANSMISSION
M6040, M7040, WSM
3-S35
Main Shift Arm
1. Remove the stopper plate (14) and seal cap (13).
2. Remove the select lever (4) then remove the select arm (3).
3. Remove the seal cap (5).
4. Remove the internal circlip (8).
5. Remove the screw (6) and remove the washer (9), spring (10)
and washer (11).
6. Remove the main shift arm (2).
7. Remove the stopper plate (12) and main shift lever (1).
(When reassembling)
• Replace the seal cap (5) and (13) with new one.
• Align the center of main shift lever (1) and projection mark (A)
at shifter cover when the shift arm (2) at neutral position.
• Apply transmission fluid to the spline.
• Assemble the select arm (3) and select lever (4) with spline,
difference them at 1.57 rad (90 °) as shown in the photo.
9Y1210143TRS0060US0
(1) Main Shift Lever
(2) Main Shift Arm
(3) Select Arm
(4) Select Lever
(5) Seal Cap
(6) Screw
(7) Washer
(8) Internal Circlip
(9) Washer
(10) Spring
(11) Washer
(12) Stopper Plate
(13) Seal Cap
(14) Stopper Plate
(A) Alignment Projection
KiSC issued 07, 2012 A