CABIN
M6040, M7040, WSM
10-S49
Seat, Mats and Floor Cover
1. See page 10-S44.
9Y1210143CAS0082US0
Air Conditioner Ducts and Covers
1. See page 10-S45.
9Y1210143CAS0083US0
Inner Cover (R.H.)
1. Remove the hand accelerator lever grip (9).
2. Remove the range gear shift lever grip (1).
3. Remove the main shift lever grip (2).
4. Remove the auxiliary control lever grips (3).
5. Remove the position control lever grip (6) and draft control lever
grip (7).
6. Pull out the switch board (16).
7. Disconnect the 5P connector (10) from front wiper switch.
8. Disconnect the 3P connector (white) (13) from front working
light switch and 3P connector (black) (12) from 4WD switch.
9. Disconnect the 3P connector (blue) (14) from rear working light
switch and 3P connector (15) from the beacon light switch.
10. Remove the inner cover 2 (5).
11. Disconnect the 2P connector (17) from cigar lighter, 3P
connector (18) from PTO switch and remove the inner cover 1
(R.H.) (5).
9Y1210143CAS0089US0
Removing Heater Hoses
1. Disconnect the heater hoses (1) and (2).
2. Pull out the heater hoses (1) and (2) from the bottom of the
cabin.
3. Take out the heater hoses (1) and (2).
(When reassembling)
• When connecting the heater hose with A/C unit, hose should be
put into the A/C unit pipe more than 30 mm (1.2 in.).
• Be sure to fix the heater hoses (1) and (2) to the original
position. Note the inlet hose and outlet hoses.
9Y1210143CAS0090US0
(1) Range Gear Shift Lever Grip
(2) Main Shift Lever Grip
(3) Auxiliary Control Lever Grip
(4) PTO Switch
(5) Inner Cover (R.H.)
(6) Position Control Lever Grip
(7) Draft Control Lever Grip
(8) Inner Cover 2
(9) Hand Accelerator Lever Grip
(10) 5P Connector (Front Wiper Switch)
(11) 3P Connector (Rear Wiper Switch)
(12) 3P Connector (4WD Switch)
(13) 3P Connector
(Front Working Light Switch)
(14) 3P Connector
(Rear Working Light Switch)
(15) 3P Connector
(Beacon Light Switch)
(16) Switch Board
(17) 2P Connector (Cigar Lighter)
(18) 3P Connector (PTO Switch)
(1) Heater Hose 1 (2) Heater Hose 2