wsm M7040 - Page 80

GENERAL
M6040, M7040, WSM
G-59
Balancer Shaft 2 Bearing B Replacing Tool
Application
• Use to press fit the bearing.
NOTE
• The following special tools are not provided, so make them referring to the figure.
9Y1210143GEG0091US0
A 18 mm (0.7087 in.) Q 0.523 rad (30 °)
B 125 mm (4.9213 in.) R 35 mm dia. (1.3780 in. dia.)
C 1.2 mm (0.0472 in.) S 9 mm (0.3543 in.)
D
4.000 to 4.018 mm dia., 7 mm depth
(0.1575 to 0.1582 in. dia., 0.2756 in. depth)
T 0.523 rad (30 °)
E 53 mm dia. (2.0866 in.) U 84.5 to 85.5 mm (3.3268 to 3.3661 in.)
F 48.8 to 48.9 mm dia. (1.9213 to 1.9252 in. dia.) V 50 mm (1.9685 in.)
G 40 mm dia. (1.5748 in. dia.) W 0.698 rad (40 °)
H 0.523 rad (30 °) X 2 mm (0.0787 in.)
I 1.5 mm (0.0591 in.) Y 3 mm (0.1181 in.)
J 20 mm dia. (0.7874 in. dia.) a 0.8 mm radius (0.0315 in. radius)
K 34.9 to 35.0 mm dia. (1.3740 to 1.3780 in. dia.) b Ra = 3.2 a
L 19.5 to 20.5 mm dia. (0.7677 to 0.8071 in. dia.) c 0.2 mm radius (0.0079 in. radius)
M 20 mm (0.7874 in.) d 8.0 mm radius (0.3150 in. radius)
N 99 mm (3.8976 in.) e 0.4 mm radius (0.0157 in. radius)
O 44 mm (1.7323 in.) C0.5 Chamfer 0.5 mm (0.0197 in.)
P 120 mm (4.7244 in.) C1 Chamfer 1.0 mm (0.0394 in.)
(1) Shaft (2) Stopper
KiSC issued 07, 2012 A