AudioCodes Mediant 800B - Page 1189

Version 7.2 1189 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description

The indexing of this table ini file parameter starts at 0.
 The parameter is applicable only to analog interfaces.
Enable Caller ID
configure voip > gateway dtmf-
supp-service supp-service-
settings
> enable-caller-id
[EnableCallerID]
Global parameter that enables Caller ID.
 [0] Disable (default)
 [1] Enable =

FXS: The calling number and display text (from IP) are
sent to the device's port.

FXO or CAS: The device detects the Caller ID signal
received from the Tel and sends it to the IP in the SIP
INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring Caller
Display Information on page 636. To enable or disable caller ID
generation / detection per port, see Configuring Caller ID
Permissions on page 640.
Caller ID Type
configure voip > gateway dtmf-
supp-service supp-service-
settings
> ccaller-ID-type
[CallerIDType]
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) / generation
(FXS) of MWI (when specified) signals:
 [0] Standard Bellcore = (Default) Caller ID and MWI
 [1] Standard ETSI = Caller ID and MWI
 [2] Standard NTT
 [4] Standard BT = Britain
 [16] Standard DTMF Based ETSI
 [17] Standard Denmark = Caller ID and MWI
 [18] Standard India
 [19] Standard Brazil
Note:
 The parameter is applicable only to analog interfaces.
 Typically, the Caller ID signals are generated / detected
between the first and second rings. However, sometimes the
Caller ID is detected before the first ring signal. In such a
scenario, set the RingsBeforeCallerID parameter to 0.
 Caller ID detection for Britain [4] is not supported on the
device’s FXO ports. Only FXS ports can generate the Britain
[4] Caller ID.
 To select the Bellcore Caller ID sub standard, use the
BellcoreCallerIDTypeOneSubStandard parameter. To select
the ETSI Caller ID substandard, use the
ETSICallerIDTypeOneSubStandard parameter.
 To select the Bellcore MWI sub standard, use the
BellcoreVMWITypeOneStandard parameter. To select the
ETSI MWI sub standard, use the
ETSIVMWITypeOneStandard parameter.
 If you define Caller ID Type as NTT [2], you need to define
the NTT DID signaling form (FSK or DTMF) using the
NTTDIDSignallingForm parameter.
Enable FXS Caller ID Category
Digit For Brazil Telecom
fxs-callid-cat-brazil
[AddCPCPrefix2BrazilCallerID]
Enables the interworking of Calling Party Category (cpc) code
from SIP INVITE messages to FXS Caller ID first digit.
 [0] Disable (default)
 [1] Enable