EasyManuals Logo

Edge-Core ECS3510-26P User Manual

Edge-Core ECS3510-26P
1026 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #279 background imageLoading...
Page #279 background image
C
HAPTER
13
| Security Measures
AAA Authorization and Accounting
– 279 –
packet from the client to the server, while TACACS+ encrypts the entire
body of the packet.
CLI REFERENCES
â—† "RADIUS Client" on page 614
â—† "TACACS+ Client" on page 618
â—† "AAA" on page 621
COMMAND USAGE
â—† If a remote authentication server is used, you must specify the
message exchange parameters for the remote authentication protocol.
Both local and remote logon authentication control management access
via the console port, web browser, or Telnet.
â—† RADIUS and TACACS+ logon authentication assign a specific privilege
level for each user name/password pair. The user name, password, and
privilege level must be configured on the authentication server. The
encryption methods used for the authentication process must also be
configured or negotiated between the authentication server and logon
client. This switch can pass authentication messages between the
server and client that have been encrypted using MD5 (Message-Digest
5), TLS (Transport Layer Security), or TTLS (Tunneled Transport Layer
Security).
PARAMETERS
These parameters are displayed:
Configure Server
â—† RADIUS
â– 
Global – Provides globally applicable RADIUS settings.
â– 
Server Index – Specifies one of five RADIUS servers that may be
configured. The switch attempts authentication using the listed
sequence of servers. The process ends when a server either
approves or denies access to a user.
â– 
Server IP Address – Address of authentication server.
(A Server Index entry must be selected to display this item.)
â– 
Accounting Server UDP Port – Network (UDP) port on
authentication server used for accounting messages.
(Range: 1-65535; Default: 1813)
â– 
Authentication Server UDP Port – Network (UDP) port on
authentication server used for authentication messages.
(Range: 1-65535; Default: 1812)
â– 
Authentication Timeout – The number of seconds the switch
waits for a reply from the RADIUS server before it resends the
request. (Range: 1-65535; Default: 5)

Table of Contents

Other manuals for Edge-Core ECS3510-26P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS3510-26P and is the answer not in the manual?

Edge-Core ECS3510-26P Specifications

General IconGeneral
BrandEdge-Core
ModelECS3510-26P
CategorySwitch
LanguageEnglish

Related product manuals