C
HAPTER
5
| Interface Configuration
Trunk Configuration
ā 152 ā
Figure 46: Configuring Connection Parameters for a Dynamic Trunk
To show the connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step list.
3. Select Show from the Action list.
Figure 47: Showing Connection Parameters for Dynamic Trunks
To show the port members of dynamic trunks:
1. Click Interface, Trunk, Dynamic.
2. Select Configure General from the Step list.
3. Select Show Member from the Action list.
Figure 48: Showing Members of Dynamic Trunks
To Next Page
Loading...
