C
HAPTER
14
| Basic Administration Protocols
Link Layer Discovery Protocol
– 382 –
Figure 210: Configuring LLDP Interface Attributes
CONFIGURING LLDP
INTERFACE CIVIC-
ADDRESS
Use the Administration > LLDP (Configure Interface – Add CA-Type) page
to specify the physical location of the device attached to an interface.
CLI REFERENCES
â—† "lldp med-location civic-addr" on page 933
COMMAND USAGE
â—† Use the Civic Address type (CA-Type) to advertise the physical location
of the device attached to an interface, including items such as the city,
street number, building and room information. The address location is
specified as a type and value pair, with the civic address type defined in
RFC 4776. The following table describes some of the CA type numbers
and provides examples.
Table 26: LLDP MED Location CA Types
CA Type Description CA Value Example
1 National subdivisions (state, canton, province) California
2County, parish Orange
3City, township Irvine
4 City division, borough, city district West Irvine
5 Neighborhood, block Riverside
6 Group of streets below the neighborhood level Exchange
18 Street suffix or type Avenue
To Next Page
Loading...
Need help?
General