C
HAPTER
30
| Automatic Traffic Control Commands
Threshold Commands
– 781 –
auto-traffic-control
auto-control-release
This command automatically releases a control response of rate-limiting
after the time specified in the auto-traffic-control release-timer command
has expired.
SYNTAX
auto-traffic-control {broadcast | multicast}
auto-control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
â—† This command can be used to automatically stop a control response of
rate-limiting after the specified action has been triggered and the
release timer has expired.
â—† To release a control response which has shut down a port after the
specified action has been triggered and the release timer has expired,
use the auto-traffic-control control-release command.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast auto-control-release
Console(config-if)#
auto-traffic-control
control-release
This command manually releases a control response.
SYNTAX
auto-traffic-control {broadcast | multicast} control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
This command can be used to manually stop a control response of rate-
limiting or port shutdown any time after the specified action has been
triggered.
To Next Page
Loading...
Need help?
General