C
HAPTER
33
| VLAN Commands
GVRP and Bridge Extension Commands
– 826 –
DEFAULT SETTING
Shows all GARP timers.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show garp timer ethernet 1/1
Eth 1/ 1 GARP timer status:
Join Timer: 20 centiseconds
Leave Timer: 60 centiseconds
Leaveall Timer: 1000 centiseconds
Console#
RELATED COMMANDS
garp timer (823)
show gvrp
configuration
This command shows if GVRP is enabled.
SYNTAX
show gvrp configuration [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-12)
DEFAULT SETTING
Shows both global and interface-specific configuration.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
GVRP Configuration : Disabled
Console#
To Next Page
Loading...
Need help?
General