C
HAPTER
36
| Multicast Filtering Commands
Multicast VLAN Registration
– 919 –
EXAMPLE
The following shows the global MVR settings:
Console#show mvr
MVR Config Status : Enabled
MVR Running Status : Active
MVR Multicast VLAN : 1
MVR Group Address : 225.0.0.5
MVR Group Count : 10
Console#
The following displays information about the interfaces attached to the
MVR VLAN:
Console#show mvr interface
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- --------------------
Eth1/ 2 Source Active/Up
Eth1/ 3 Source Inactive/Down
Eth1/ 1 Receiver Active/Up Disabled 225.0.0.1(VLAN1)
225.0.0.9(VLAN3)
Eth1/ 4 Receiver Active/Down Disabled
Console#
Table 131: show mvr - display description
Field Description
MVR Config Status Shows if MVR is globally enabled on the switch.
MVR Running Status Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR
Status is enabled, and the specified MVR VLAN exists.)
MVR Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.
MVR Group Address A multicast service sent to all attached subscribers
MVR Group Count The number of contiguous MVR group addresses.
Table 132: show mvr interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source
ports is “ACTIVE” if MVR is globally enabled on the switch. MVR
status for receiver ports is “ACTIVE” only if there are subscribers
receiving multicast traffic from one of the MVR groups, or a
multicast group has been statically assigned to an interface.
Immediate Leave Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the
receiver VLAN.
To Next Page
Loading...
Need help?
General