C
HAPTER
16
| IP Services
Configuring a List of Domain Names
– 464 –
WEB INTERFACE
To configure general settings for DNS:
1. Click IP Service, DNS, General.
2. Select Configure Global from the Action list.
3. Enable domain lookup, and set the default domain name.
4. Click Apply.
Figure 274: Configuring General Settings for DNS
CONFIGURING A LIST OF DOMAIN NAMES
Use the IP Service > DNS - General (Add Domain Name) page to configure
a list of domain names to be tried in sequential order.
CLI REFERENCES
â—† "ip domain-list" on page 945
â—† "show dns" on page 951
COMMAND USAGE
â—† Use this page to define a list of domain names that can be appended to
incomplete host names (i.e., host names passed from a client that are
not formatted with dotted notation).
â—† If there is no domain list, the default domain name is used (see
"Configuring General DNS Service Parameters" on page 463). If there is
a domain list, the system will search it for a corresponding entry. If
none is found, it will use the default domain name.
â—† When an incomplete host name is received by the DNS service on this
switch and a domain name list has been specified, the switch will work
through the domain list, appending each domain name in the list to the
host name, and checking with the specified name servers for a match
(see "Configuring a List of Name Servers" on page 466).
To Next Page
Loading...
Need help?
General