C
HAPTER
30
| Automatic Traffic Control Commands
Threshold Commands
– 778 –
EXAMPLE
This example enables automatic storm control for broadcast traffic on port
1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast
Console(config-if)#
auto-traffic-control
action
This command sets the control action to limit ingress traffic or shut down
the offending port. Use the no form to restore the default setting.
SYNTAX
auto-traffic-control
{
broadcast
|
multicast
}
action
{
rate-control
|
shutdown
}
no auto-traffic-control {broadcast | multicast} action
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
rate-control
- If a control response is triggered, the rate of ingress
traffic is limited based on the threshold configured by the auto-
traffic-control alarm-clear-threshold command.
shutdown
- If a control response is triggered, the port is
administratively disabled. A port disabled by automatic traffic
control can only be manually re-enabled.
DEFAULT SETTING
rate-control
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
â—† When the upper threshold is exceeded and the apply timer expires, a
control response will be triggered based on this command.
â—† When the control response is set to rate limiting by this command, the
rate limits are determined by the auto-traffic-control alarm-clear-
threshold command.
â—† If the control response is to limit the rate of ingress traffic, it can be
automatically terminated once the traffic rate has fallen beneath the
lower threshold and the release timer has expired.
â—† If a port has been shut down by a control response, it will not be re-
enabled by automatic traffic control. It can only be manually re-enabled
using the auto-traffic-control control-release command.
To Next Page
Loading...
Need help?
General