C
HAPTER
20
| System Management Commands
Time
– 570 –
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is east (before) or west (after) of UTC.
EXAMPLE
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
RELATED COMMANDS
show sntp (567)
clock timezone-
predefined
This command uses predefined time zone configurations to set the time
zone for the switch’s internal clock. Use the no form to restore the default.
SYNTAX
clock timezone-predefined offset-city
no clock timezone-predefined
offset - Select the offset from GMT. (Range: GMT-0100 - GMT-1200;
GMT-Greenwich-Mean-Time; GMT+0100 - GMT+1300)
city - Select the city associated with the chosen GMT offset. After
the offset has been entered, use the tab-complete function to
display the available city options.
DEFAULT SETTING
GMT-Greenwich-Mean-Time-Dublin,Edinburgh,Lisbon,London
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on
the earth’s prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is east (before) or west (after) of UTC.
EXAMPLE
Console(config)#clock timezone-predefined GMT-0930-Taiohae
Console(config)#
RELATED COMMANDS
show sntp (567)
To Next Page
Loading...
Need help?
General