C
HAPTER
26
| Interface Commands
Interface Configuration
– 744 –
show interfaces
transceiver
This command displays identifying information for the specified transceiver,
including connector type and vendor-related parameters, as well as the
temperature, voltage, bias current, transmit power, and receive power.
SYNTAX
show interfaces transceiver [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 25-26)
DEFAULT SETTING
Shows all SFP interfaces.
COMMAND MODE
Privileged Exec
COMMAND USAGE
The switch can display diagnostic information for SFP modules which
support the SFF-8472 Specification for Diagnostic Monitoring Interface for
Optical Transceivers. This information allows administrators to remotely
diagnose problems with optical devices.
EXAMPLE
Console#show interfaces transceiver ethernet 1/25
SFP Information of Ethernet 1/25
Identifier : Unknown or unspecified
Connector : LC
Transceiver:
Gigabit Ethernet Compliance Codes:
1000BASE-SX
Fibre Channel link length:
intermediate distance(I)
Fibre Channel transmitter technology:
Shortwave laser w/o OFC(SN)
Fibre Channel transmission media:
Multimode, 50um(M5, M5E)
Multimode, 62.5um(M6)
Fibre Channel Speed:
100 MBytes/sec
Encoding : 8B/10B
BR.Norminal: 13MBits/sec
BR.MAX : 0
BR.MIN : 0
802.1Q-tunnel
Mode
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Uplink (page 838).
802.1Q-tunnel
TPID
Shows the Tag Protocol Identifier used for learning and switching packets
(page 839).
Table 93: show interfaces switchport - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General