C
HAPTER
13
| Security Measures
Access Control Lists
– 328 –
3. Select Add Rule from the Action list.
4. Select ARP from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the packet type (Request, Response, All).
8. Select the address type (Any, Host, or IP).
9. If you select “Host,” enter a specific address (e.g., 11-22-33-44-55-
66). If you select “IP,” enter a base address and a hexadecimal bit mask
for an address range.
10. Enable logging if required.
11. Click Apply.
Figure 177: Configuring a ARP ACL
BINDING A PORT TO AN
ACCESS CONTROL
LIST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI REFERENCES
◆ "ip access-group" on page 717
◆ "show ip access-group" on page 717
◆ "mac access-group" on page 722
◆ "show mac access-group" on page 722
◆ "Time Range" on page 572
To Next Page
Loading...
