C
HAPTER
17
| Multicast Filtering
Multicast VLAN Registration
– 500 –
4. Select the port for which to display this information.
Figure 303: Showing the Static MVR Groups Assigned to a Port
DISPLAYING MVR
RECEIVER GROUPS
Use the Multicast > MVR (Show Member) page to show the multicast
groups either statically or dynamically assigned to the MVR receiver groups
on each interface.
CLI REFERENCES
â—† "show mvr" on page 918
PARAMETERS
These parameters are displayed:
◆ Group IP Address – Multicast groups assigned to the MVR VLAN.
◆ Source IP Address – Indicates the source address of the multicast
service, or displays an asterisk if the group address has been statically
assigned.
◆ VLAN – Indicates the MVR VLAN receiving the multicast service.
◆ Forwarding Port – Shows the interfaces with subscribers for multicast
services provided through the MVR VLAN. Also shows the VLAN through
which the service is received. Note that this may be different from the
MVR VLAN if the group address has been statically assigned.
WEB INTERFACE
To show the interfaces associated with multicast groups assigned to the
MVR VLAN:
1. Click Multicast, MVR.
2. Select Show Member from the Step list.
To Next Page
Loading...
Need help?
General