Edge-Core ECS3510-26P User Manual

C HAPTER 30 | Automatic Traffic Control Commands
SNMP Trap Commands
– 783 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-fire
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-fire-threshold (780)
snmp-server enable
port-traps atc
broadcast-control-
apply
This command sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer expires. Use the
no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc broadcast-control-apply
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-apply
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-fire-threshold (780)
auto-traffic-control apply-timer (776)
snmp-server enable
port-traps atc
broadcast-control-
release
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc
broadcast-control-release
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)

Edge-Core ECS3510-26P Specifications

General

Model	ECS3510-26P
Type	Managed
PoE Ports	24
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
MAC Address Table Size	16K
VLANs	4K
Power Supply	100-240VAC, 50-60 Hz
Dimensions	440 x 260 x 44 mm
Ports	24 x 10/100/1000BASE-T + 2 x 10G SFP+
Layer	Layer 2+