C
HAPTER
23
| Authentication Commands
Web Server
– 631 –
ip http secure-port This command specifies the UDP port number used for HTTPS connection to
the switch’s web interface. Use the no form to restore the default port.
SYNTAX
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
DEFAULT SETTING
443
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† If you change the HTTPS port number, clients attempting to connect to
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
EXAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
RELATED COMMANDS
ip http secure-server (631)
show system (530)
ip http
secure-server
This command enables the secure hypertext transfer protocol (HTTPS) over
the Secure Socket Layer (SSL), providing secure access (i.e., an encrypted
connection) to the switch’s web interface. Use the no form to disable this
function.
SYNTAX
[no] ip http secure-server
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† HTTP and HTTPS are implemented as mutually exclusive services on the
switch.
â—† If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
To Next Page
Loading...
Need help?
General