C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 413 –
To show local SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Local User from the Action list.
Figure 234: Showing Local SNMPv3 Users
CONFIGURING REMOTE
SNMPV3 USERS
Use the Administration > SNMP (Configure User - Add SNMPv3 Remote
User) page to identify the source of SNMPv3 inform messages sent from
the local switch. Each SNMPv3 user is defined by a unique name. Users
must be configured with a specific security level and assigned to a group.
The SNMPv3 group restricts users to a specific read, write, and notify view.
CLI REFERENCES
â—† "snmp-server user" on page 591
COMMAND USAGE
â—† To grant management access to an SNMPv3 user on a remote device,
you must first specify the engine identifier for the SNMP agent on the
remote device where the user resides. The remote engine ID is used to
compute the security digest for authentication and encryption of
packets passed between the switch and the remote user. (See
"Specifying Trap Managers" on page 415 and "Specifying a Remote
Engine ID" on page 401.)
PARAMETERS
These parameters are displayed:
◆ User Name – The name of user connecting to the SNMP agent.
(Range: 1-32 characters)
◆ Group Name – The name of the SNMP group to which the user is
assigned. (Range: 1-32 characters)
◆ Remote IP – The Internet address of the remote device where the
user resides.
◆ Security Model – The user security model; SNMP v1, v2c or v3.
(Default: v3)
To Next Page
Loading...
Need help?
General