C
HAPTER
20
| System Management Commands
Event Logging
– 558 –
RELATED COMMANDS
logging history (556)
logging trap (558)
clear log (558)
logging trap This command enables the logging of system messages to a remote server,
or limits the syslog messages saved to a remote server based on severity.
Use this command without a specified level to enable remote logging. Use
the no form to disable remote logging.
SYNTAX
logging trap [level level]
no logging trap [level]
level - One of the syslog severity levels listed in the table on
page 556. Messages sent include the selected level through level 0.
DEFAULT SETTING
Disabled
Level 7
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Using this command with a specified level enables remote logging and
sets the minimum severity level to be saved.
â—† Using this command without a specified level also enables remote
logging, but restores the minimum severity level to the default.
EXAMPLE
Console(config)#logging trap 4
Console(config)#
clear log This command clears messages from the log buffer.
SYNTAX
clear log [flash | ram]
flash - Event history stored in flash memory (i.e., permanent
memory).
ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
DEFAULT SETTING
Flash and RAM
To Next Page
Loading...
Need help?
General