C
HAPTER
20
| System Management Commands
SMTP Alerts
– 564 –
EXAMPLE
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
logging sendmail
source-email
This command sets the email address used for the “From” field in alert
messages. Use the no form to restore the default value.
SYNTAX
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
EXAMPLE
Console(config)#logging sendmail source-email bill@this-company.com
Console(config)#
show logging
sendmail
This command displays the settings for the SMTP event handler.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP Minimum Severity Level: 7
SMTP destination email addresses
-----------------------------------------------
ted@this-company.com
SMTP Source Email Address: bill@this-company.com
To Next Page
Loading...
Need help?
General