C
HAPTER
21
| SNMP Commands
General SNMP Commands
– 584 –
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#snmp-server contact Paul
Console(config)#
RELATED COMMANDS
snmp-server location (584)
snmp-server
location
This command sets the system location string. Use the no form to remove
the location string.
SYNTAX
snmp-server location text
no snmp-server location
text - String that describes the system location.
(Maximum length: 255 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#snmp-server location WC-19
Console(config)#
RELATED COMMANDS
snmp-server contact (583)
show snmp This command can be used to check the status of SNMP communications.
DEFAULT SETTING
None
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
This command provides information on the community access strings,
counter information for SNMP input and output protocol data units, and
whether or not SNMP logging has been enabled with the snmp-server
enable traps command.
To Next Page
Loading...
Need help?
General