C
HAPTER
9
| Congestion Control
Automatic Traffic Control
– 237 –
WEB INTERFACE
To configure the response timers for automatic storm control:
1. Click Traffic, Congestion Control, Automatic Storm Control.
2. Select Configure Interface from the Step field.
3. Enable or disable ATC as required, set the control response, specify
whether or not to automatically release the control response of rate
limiting, set the upper and lower thresholds, and specify which trap
messages to send.
4. Click Apply.
Figure 112: Configuring ATC Interface Attributes
To Next Page
Loading...
Need help?
General