– 97 –
4 BASIC MANAGEMENT TASKS
This chapter describes the following topics:
◆ Displaying System Information – Provides basic system description,
including contact information.
◆ Displaying Hardware/Software Versions – Shows the hardware version,
power status, and firmware versions
◆ Configuring Support for Jumbo Frames – Enables support for jumbo
frames.
◆ Displaying Bridge Extension Capabilities – Shows the bridge extension
parameters.
◆ Managing System Files – Describes how to upgrade operating software
or configuration files, and set the system start-up files.
◆ Setting the System Clock – Sets the current time manually or through
specified SNTP servers.
◆ Configuring the Console Port – Sets console port connection
parameters.
◆ Configuring Telnet Settings – Sets Telnet connection parameters.
◆ Displaying CPU Utilization – Displays information on CPU utilization.
◆ Displaying Memory Utilization – Shows memory utilization parameters.
◆ Resetting the System – Restarts the switch immediately, at a specified
time, after a specified delay, or at a periodic interval.
DISPLAYING SYSTEM INFORMATION
Use the System > General page to identify the system by displaying
information such as the device name, location and contact information.
CLI REFERENCES
â—† "System Management Commands" on page 525
â—† "SNMP Commands" on page 581
To Next Page
Loading...
Need help?
General