C
HAPTER
21
| SNMP Commands
General SNMP Commands
– 582 –
General SNMP Commands
snmp-server This command enables the SNMPv3 engine and services for all
management clients (i.e., versions 1, 2c, 3). Use the no form to disable the
server.
SYNTAX
[no] snmp-server
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
Notification Log Commands
nlm Enables the specified notification log GC
snmp-server notify-filter Creates a notification log and specifies the target host GC
show nlm oper-status Shows operation status of configured notification logs PE
show snmp notify-filter Displays the configured notification logs PE
ATC Trap Commands
snmp-server enable port-
traps atc broadcast-
alarm-clear
Sends a trap when broadcast traffic falls beneath the
lower threshold after a storm control response has
been triggered
IC (Port)
snmp-server enable port-
traps atc broadcast-
alarm-fire
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc broadcast-
control-apply
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply
timer expires
IC (Port)
snmp-server enable port-
traps atc broadcast-
control-release
Sends a trap when broadcast traffic falls beneath the
lower threshold after a storm control response has
been triggered and the release timer expires
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
clear
Sends a trap when multicast traffic falls beneath the
lower threshold after a storm control response has
been triggered
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
fire
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc multicast-
control-apply
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply
timer expires
IC (Port)
snmp-server enable port-
traps atc multicast-
control-release
Sends a trap when multicast traffic falls beneath the
lower threshold after a storm control response has
been triggered and the release timer expires
IC (Port)
Table 57: SNMP Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General