C
HAPTER
21
| SNMP Commands
SNMPv3 Commands
– 591 –
â—† For additional information on the notification messages supported by
this switch, see Table 32, "Supported Notification Messages," on
page 406. Also, note that the authentication, link-up and link-down
messages are legacy traps and must therefore be enabled in
conjunction with the snmp-server enable traps command.
EXAMPLE
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
snmp-server user This command adds a user to an SNMP group, restricting the user to a
specific SNMP Read, Write, or Notify View. Use the no form to remove a
user from an SNMP group.
SYNTAX
snmp-server user username groupname [remote ip-address]
{v1 | v2c | v3 [encrypted] [auth {md5 | sha} auth-password
[priv des56 priv-password]]
no snmp-server user username {v1 | v2c | v3 | remote}
username - Name of user connecting to the SNMP agent.
(Range: 1-32 characters)
groupname - Name of an SNMP group to which the user is assigned.
(Range: 1-32 characters)
remote - Specifies an SNMP engine on a remote device.
ip-address - The Internet address of the remote device.
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
encrypted - Accepts the password as encrypted input.
auth - Uses SNMPv3 with authentication.
md5 | sha - Uses MD5 or SHA authentication.
auth-password - Authentication password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password. (A minimum of eight characters is required.)
priv des56 - Uses SNMPv3 with privacy with DES56 encryption.
priv-password - Privacy password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
To Next Page
Loading...
Need help?
General