C
HAPTER
20
| System Management Commands
Time
– 568 –
EXAMPLE
Console#show sntp
Current Time : Nov 5 18:51:22 2006
Poll Interval : 16 seconds
Current Mode : Unicast
SNTP Status : Enabled
SNTP Server : 137.92.140.80 0.0.0.0 0.0.0.0
Current Server : 137.92.140.80
Console#
Manual Configuration Commands
clock summer-time This command sets the start, end, and offset times of summer time
(daylight savings time) for the switch on a one-time basis. Use the no form
to disable summer time.
SYNTAX
clock summer-time name date b-date b-month b-year b-hour
b-minute e-date e-month e-year e-hour e-minute [offset]
no clock summer-time
name - Name of the time zone while summer time is in effect,
usually an acronym. (Range: 1-30 characters)
b-date - Day of the month when summer time will begin.
(Range: 1-31)
b-month - The month when summer time will begin.
(Options: january | february | march | april | may | june | july
| august | september | october | november | december)
b-year- The year summer time will begin.
b-hour - The hour summer time will begin. (Range: 0-23 hours)
b-minute - The minute summer time will begin. (Range: 0-59
minutes)
e-date - Day of the month when summer time will end.
(Range: 1-31)
e-month - The month when summer time will end.
(Options: january | february | march | april | may | june |
july | august | september | october | november | december)
e-year - The year summer time will end.
e-hour - The hour summer time will end. (Range: 0-23 hours)
e-minute - The minute summer time will end. (Range: 0-59
minutes)
offset - Summer time offset from the regular time zone, in minutes.
(Range: 0-99 minutes)
DEFAULT SETTING
Disabled
To Next Page
Loading...
Need help?
General