C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 415 –
Figure 235: Configuring Remote SNMPv3 Users
To show remote SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Remote User from the Action list.
Figure 236: Showing Remote SNMPv3 Users
SPECIFYING TRAP
MANAGERS
Use the Administration > SNMP (Configure Trap) page to specify the host
devices to be sent notifications and the types of notifications to send.
Notifications indicating status changes are issued by the switch to the
specified notification managers. You must specify notification managers so
that key events are reported by this switch to your management station
(using network management software). You can specify up to five
management stations that will receive authentication failure messages and
other notification messages from the switch.
CLI REFERENCES
â—† "snmp-server host" on page 586
â—† "snmp-server enable traps" on page 585
To Next Page
Loading...
Need help?
General