Edge-Core ECS3510-26P User Manual

C HAPTER 37 | LLDP Commands
– 927 –
lldp admin-status This command enables LLDP transmit, receive, or transmit and receive
mode on the specified port. Use the no form to disable this feature.
SYNTAX
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
DEFAULT SETTING
tx-rx
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp basic-tlv
management-ip-
address
This command configures an LLDP-enabled port to advertise the
management address for this device. Use the no form to disable this
feature.
SYNTAX
[no] lldp basic-tlv management-ip-address
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ The management address protocol packet includes the IPv4 address of
the switch. If no management address is available, the address should
be the MAC address for the CPU or for the port sending this
advertisement.
◆ The management address TLV may also include information about the
specific interface associated with this address, and an object identifier
indicating the type of hardware component or protocol entity associated
with this address. The interface number and OID are included to assist
SNMP applications to perform network discovery by indicating

Edge-Core ECS3510-26P Specifications

General

Model	ECS3510-26P
Type	Managed
PoE Ports	24
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
MAC Address Table Size	16K
VLANs	4K
Power Supply	100-240VAC, 50-60 Hz
Dimensions	440 x 260 x 44 mm
Ports	24 x 10/100/1000BASE-T + 2 x 10G SFP+
Layer	Layer 2+