C
HAPTER
14
| Basic Administration Protocols
Setting A Time Range
– 435 –
Figure 255: Managing a Cluster Member
SETTING A TIME RANGE
Use the Administration > Time Range page to sets a time range for ACLs.
CLI REFERENCES
◆ "Time Range" on page 572
COMMAND USAGE
If both an absolute rule and one or more periodic rules are configured for
the same time range (i.e., named entry), that entry will only take effect if
the current time is within the absolute time range and one of the periodic
time ranges.
PARAMETERS
These parameters are displayed:
Add
◆ Time-Range Name – Name of a time range. (Range: 1-16 characters)
Add Rule
◆ Time-Range – Name of a time range.
◆ Mode
■
Absolute – Specifies a specific time or time range.
■
Start/End – Specifies the hours, minutes, month, day, and year
at which to start or end.
■
Periodic – Specifies a periodic interval.
■
Start/To – Specifies the days of the week, hours, and minutes
at which to start or end.
To Next Page
Loading...
