C
HAPTER
13
| Security Measures
Network Access (MAC Address Authentication)
– 302 –
5. Click Apply.
Figure 159: Configuring Interface Settings for Network Access
CONFIGURING PORT
LINK DETECTION
Use the Security > Network Access (Configure Interface - Link Detection)
page to send an SNMP trap and/or shut down a port when a link event
occurs.
CLI REFERENCES
â—† "Network Access (MAC Address Authentication)" on page 666
PARAMETERS
These parameters are displayed:
◆ Link Detection Status – Configures whether Link Detection is enabled
or disabled for a port.
◆ Condition – The link event type which will trigger the port action.
â–
Link up – Only link up events will trigger the port action.
â–
Link down – Only link down events will trigger the port action.
â–
Link up and down – All link up and link down events will trigger
the port action.
◆ Action – The switch can respond in three ways to a link up or down
trigger event.
â–
Trap – An SNMP trap is sent.
â–
Trap and shutdown – An SNMP trap is sent and the port is shut
down.
â–
Shutdown – The port is shut down.
To Next Page
Loading...
Need help?
General