Edge-Core ECS3510-26P User Manual

C HAPTER 24 | General Security Measures
Network Access (MAC Address Authentication)
– 673 –
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable
the port.
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection link-up action trap
Console(config-if)#
network-access
link-detection
link-up-down
Use this command to detect link-up and link-down events. When either
event is detected, the switch can shut down the port, send an SNMP trap,
or both. Use the no form of this command to disable this feature.
SYNTAX
network-access link-detection link-up-down
action [shutdown | trap | trap-and-shutdown]
no network-access link-detection
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable
the port.
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection link-up-down action trap
Console(config-if)#

Edge-Core ECS3510-26P Specifications

General

Model	ECS3510-26P
Type	Managed
PoE Ports	24
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
MAC Address Table Size	16K
VLANs	4K
Power Supply	100-240VAC, 50-60 Hz
Dimensions	440 x 260 x 44 mm
Ports	24 x 10/100/1000BASE-T + 2 x 10G SFP+
Layer	Layer 2+