C
HAPTER
20
| System Management Commands
System Status
– 526 –
hostname This command specifies or modifies the host name for this device. Use the
no form to restore the default host name.
SYNTAX
hostname name
no hostname
name - The name of this host. (Maximum length: 255 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#hostname RD#1
Console(config)#
SYSTEM STATUS
This section describes commands used to display system information.
Table 44: System Status Commands
Command Function Mode
show access-list tcam-
utilization
Shows utilization parameters for TCAM PE
show memory Shows memory utilization parameters NE, PE
show process cpu Shows CPU utilization parameters NE, PE
show running-config Displays the configuration data currently in use PE
show startup-config Displays the contents of the configuration file (stored
in flash memory) that is used to start up the system
PE
show system Displays system information NE, PE
show tech-support Displays a detailed list of system settings designed to
help technical support resolve configuration or
functional problems
PE
show users Shows all active console and Telnet sessions, including
user name, idle time, and IP address of Telnet clients
NE, PE
show version Displays version information for the system NE, PE
To Next Page
Loading...
Need help?
General