C
HAPTER
23
| Authentication Commands
AAA
– 624 –
group - Specifies the server group to use.
radius - Specifies all RADIUS hosts configure with the radius-
server host command.
tacacs+ - Specifies all TACACS+ hosts configure with the
tacacs-server host command.
server-group - Specifies the name of a server group configured
with the aaa group server command. (Range: 1-255 characters)
DEFAULT SETTING
Accounting is not enabled
No servers are specified
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† This command runs accounting for Exec service requests for the local
console and Telnet connections.
â—† Note that the default and method-name fields are only used to
describe the accounting method(s) configured on the specified RADIUS
or TACACS+ servers, and do not actually send any information to the
servers about the methods to use.
EXAMPLE
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#
aaa accounting
update
This command enables the sending of periodic updates to the accounting
server. Use the no form to restore the default setting.
SYNTAX
aaa accounting update [periodic interval]
no aaa accounting update
interval - Sends an interim accounting record to the server at this
interval. (Range: 0-2147483647 minutes; where 0 means disabled)
DEFAULT SETTING
1 minute
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† When accounting updates are enabled, the switch issues periodic
interim accounting records for all users on the system.
To Next Page
Loading...
Need help?
General