C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 418 –
â–
Retry times – The maximum number of times to resend an
inform message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
◆ Local User Name – The name of a local user which is used to identify
the source of SNMPv3 notification messages sent from the local switch.
(Range: 1-32 characters)
If an account for the specified user has not been created (page 411),
one will be automatically generated.
◆ Remote User Name – The name of a remote user which is used to
identify the source of SNMPv3 inform messages sent from the local
switch. (Range: 1-32 characters)
If an account for the specified user has not been created (page 413),
one will be automatically generated.
◆ UDP Port – Specifies the UDP port number used by the notification
manager. (Default: 162)
◆ Security Level – When notification version 3 is selected, you must
specify one of the following security levels. (Default: noAuthNoPriv)
â–
noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
â–
AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted.
â–
AuthPriv – SNMP communications use both authentication and
encryption.
WEB INTERFACE
To configure notification managers:
1. Click Administration, SNMP.
2. Select Configure Trap from the Step list.
3. Select Add from the Action list.
4. Fill in the required parameters based on the selected SNMP version.
5. Click Apply
To Next Page
Loading...
Need help?
General