C
HAPTER
17
| Multicast Filtering
Layer 2 IGMP (Snooping and Query)
– 478 –
CLI REFERENCES
â—† "Static Multicast Routing" on page 906
COMMAND USAGE
IGMP Snooping must be enabled globally on the switch (see "Configuring
IGMP Snooping and Query Parameters" on page 474) before a multicast
router port can take effect.
PARAMETERS
These parameters are displayed:
Add Static Multicast Router
◆ VLAN – Selects the VLAN which is to propagate all multicast traffic
coming from the attached multicast router. (Range: 1-4093)
◆ Interface – Activates the Port or Trunk scroll down list.
◆ Port or Trunk – Specifies the interface attached to a multicast router.
Show Static Multicast Router
◆ VLAN – Selects the VLAN for which to display any configured static
multicast routers.
◆ Interface – Shows the interface to which the specified static multicast
routers are attached.
Show Current Multicast Router
◆ VLAN – Selects the VLAN for which to display any currently active
multicast routers.
◆ Interface – Shows the interface to which an active multicast router is
attached.
◆ Type – Shows if this entry is static or dynamic.
WEB INTERFACE
To specify a static interface attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Add Static Multicast Router from the Action list.
3. Select the VLAN which will forward all the corresponding multicast
traffic, and select the port or trunk attached to the multicast router.
4. Click Apply.
To Next Page
Loading...
Need help?
General